Maintenance Description
9-30 Issue 8.0 July 2002
test auto turnup in progress An auto turnup test is in progress.
test telemetry in progress A telemetry test is in progress.
TG auto switch A TG3 circuit pack has been automatically
switched to protection.
Likely cause: Failure of a TG3 circuit pack,
removal of a TG3 circuit pack, or a TG3
circuit pack warming up.
TG manual switch A TG3 circuit pack was switched to
protection with a priority of "manual switch."
TG warming up A TG circuit pack has been installed and is
warming up to a stable operating
temperature.
TG3 failure Failure of TG3 circuit pack.
TG3 removed TG3 circuit pack is missing from slot.
TL-1 link failure An incoming TL1 link failure has been
detected.
TOHCTL failure Failure of TOHCTL circuit pack.
TOHCTL removed TOHCTL circuit pack is missing from slot.
traffic squelched Multiple failures in the ring network have
resulted in traffic being squelched to
eliminate any possibility of its being
misrouted.
transmit parameter-out-of-range One or more of the operating parameters of
a RCVR, TRMTR, or REGENR circuit pack
has exceeded the recommended range.
TRMTR failure Failure of TRMTR circuit pack.
TRMTR removed TRMTR circuit pack is missing from slot.
unexpected CP type A circuit pack has been replaced with a
defective circuit pack.
x-conn provisioned but not est A cross-connection has been entered
between a tributary of an OC-48 line and a
low-speed interface slot in the AUTO state.
Table 9-2. Condition Descriptions (Contd)
Description (from Retrieve-Alarm Report) Meaning
To Next Page
Loading...
Need help?
General