Craft Interface Terminal Usage
11-6 Issue 8.0 July 2002
When labeled LOGOUT, this key permits the user to terminate the
connection to the FT-2000 network element.
When labeled CHECK, this key sends the autobaud character sequence
(break, enter, enter) to an FT-2000 network element.
When labeled EXIT, this key permits the user to terminate the connection
and exit the FT-2000 CIT-PC software, returning the user back to the
MS-DOS
prompt.
When labeled SETUP, this key permits the user to configure the operating
parameters of the PC.
When labeled PRINT, this key permits the user to send the FT-2000
network element output to a printer, to a file, or to both.
When labeled CANCEL, this key permits the user to discard all user entries
for the current command or cancels the dial request. If F8 is pressed after
executing a command, an attempt to cancel the command is sent to the
FT-2000 network element.
When labeled EXECUTE, this key permits the user to execute the
completed command (valid parameter values).
When labeled REPEAT, this key permits the user to repeat the last
command or display the last command and edit it.
When labeled ALARM, this key permits the user to execute a
Retrieve-Alarm:All command with a single keystroke.
Currently, this key is not being used.
F4
F5
F6
F7
F8
F9
F10