Craft Interface Terminal Usage
Issue 8.0 July 2002
11-23
Table 11-6. Release 3 Inputs (Commands) Menu for FT-2000 Add/Drop-Rings Terminal
Management
Verb
First Second Security Report
Category Modifier Modifier Level Example
Retrieve Alarm and Status Report Only 2
History Report Only 15
Network Alarms Report Only 20
State Report Only 46
Switch Line General
Low Speed General
Synchronization Hardware General
FAULT Mode General
Reference General
Alarm General
Auto Turnup DSX General
Test Local General
LED General
Telemetry Parallel General
Serial General
Operate Alarm Cutoff Report Only
Loopback T3 General
Release Loopback T3 General
Allow Alarm General
Inhibit Alarm General
Reset General
Attribute Alarm Report Only 4
Control Report Only 5
Environment Report Only 6
Crossconnection STS3 Report Only 10
Date Report Only 11
Retrieve Equipment Report Only 13
Low Speed Report Only 17
CONFIGURATION Map Ring Report Only 19
OC48 Report Only 23
Protection Line Report Only 40
Synchronization Report Only 47
T3 Report Only 48
Set Attribute Alarm General
Control General
Environment General
Date General
LowSpeed General
To Next Page
Loading...