Lucent Technologies FT-2000 OC-48 - Page 745

Craft Interface Terminal Usage
Issue 8.0 July 2002
11-37
PERFORMANCE-Retrieve- PM Threshold-EC1 EC1 Performance Monitoring Threshold Value
Report
35
PERFORMANCE-Retrieve- PM Threshold-Line OC-48 Line Performance Monitoring Threshold
Value Report
36
PERFORMANCE-Retrieve-
PM Threshold-Optics OC-48 Optics Performance Monitoring
Threshold Value Report
37
PERFORMANCE-Retrieve- PM Threshold-Section STS-48 Section Performance Monitoring
Threshold Value Report
38
PERFORMANCE-Retrieve-
PM Threshold-STS1 STS-1 Path Performance Monitoring Threshold
Value Report
39
PERFORMANCE-Retrieve- PM Threshold-T3 DS-3 Performance Monitoring Threshold Value
Report
40
CONFIGURATION-Retrieve-
Protection-Line Network Element Protection Switching
Provisioning Report
41
CONFIGURATION-Retrieve- Protection-Low Speed Low Speed Protection Switching Provisioning
Report
42
SECURITY-Retrieve-
Security-Network Element Access Security Global Configuration Report 43
SECURITY-Retrieve-
Security-Port Access Port Security Configuration Report 44
CONFIGURATION-Retrieve-Squelch Map-STS1 STS-1 Squelch Map Report 45
CONFIGURATION-Retrieve-Squelch Map-STS3 STS-3 Squelch Map Report 46
FAULT-Retrieve-
State State Report 47
CONFIGURATION-Retrieve-
Synchronization Synchronization Report 48
CONFIGURATION-Retrieve-
T3 T3 Port Provisioning Report 49
CONFIGURATION-Retrieve-
Timeslot-STS1 STS-1 Tributary Map Circuit Report 50
CONFIGURATION-Retrieve-
Timeslot-STS3 STS-3 Tributary Map Report 51
Note: These reports appear on the following pages.
Table 11-9. List of Inputs (Commands) That Generate Reports (Contd)
[Alphabetized by Qualifier(s)]
Input (Command) Report (Note) Example