Craft Interface Terminal Usage
Issue 8.0 July 2002
11-67
Release 2 (Use the SECURITY category.)
The above report shows that access to a remote location over the data
communications channel (DCC) is enabled (access is allowed). This report is not
available at a repeater site.
The fields of the report are described below:
DCC Address - Shows the access identifier of the SONET data communications
channel.
Far End
Terminal
- Shows the far-end terminal manufacturer, "Lucent
Technologies" or "Other."
Remote
Activity
Reporting
- Shows that remote reporting is enabled or disabled. For
example, when enabled, far-end activity is indicated by the FE
ACTY LED being lit and reported in the Retrieve-Network Alarms
Report.
Remote
Office
Alarms
- Shows that the remote office alarms are allowed to be displayed
locally (enabled) or not (disabled). For example, when disabled,
only local office alarms are reported locally.
Far End TBOS - Shows that the far-end parallel telemetry (TBOS) is allowed to
be displayed locally (enabled) or not (disabled).
Lucent Technologies-FT-2000 96-07-19 23:15:15 EST
M Retrieve-Far End Communications:DCC: COMPLD
/* Far End Communication Configuration Report
======================================================================
Far Remote Remote Far
DCC End Activity Office End
Address Terminal Reporting Alarms TBOS
======================================================================
dcc Lucent Technologies enabled disabled enabled
*/
To Next Page
Loading...