Craft Interface Terminal Usage
Issue 8.0 July 2002
11-151
The fields of the report are described below:
At Node/ - Shows the target identifier (TID) of the node where the report is
requested (topmost entry).
TID - Shows the TIDs in a West-to-East ring direction (top to bottom).
The second entry from the top is the node immediately East of
the node requesting the report. A question mark (?) indicates the
cross-connection table is not available at that particular node.
West - Shows the direction of the line and tributary.
Cross-
connection
- Shows the direction and slot number where the STS3 signal is
connected for an add and/or drop connection. Only direction is
shown for a through tributary cross-connection. Blank spaces are
shown when a tributary is not cross-connected.
East - Shows the direction of the line and tributary.
TID - Shows the TID of the node immediately East of the node
requesting the report. A question mark (?) indicates the
cross-connection table is not available at that particular node.
To Next Page
Loading...