Operation and Maintenance (TOP)
x Issue 8.0 July 2002
8. If the expected response is not observed and a specific trouble-clearing
reference is not made, you should reference the "Trouble Clearing Task
Index" to start trouble clearing.
9. If you need help in clearing a trouble after completing all the applicable
trouble-clearing procedures in this section, contact your local or regional
maintenance assistance group. Then, the group may contact the Regional
Technical Assistance Center (RTAC) at 1-800-225-RTAC in accordance
with local procedures.
Faulty equipment being returned for repair should be sent to the following address:
Lucent Technologies
RS&R Department
1600 Osgood Street
North Andover, Massachusetts 01845
Screen Display and Equipment Designation
Fonts 0
The procedures in this manual use a MONOSPACE font to identify text on a
screen or a response displayed from the network. A BOLD font identifies the
lettering designations on panels, shelves, and circuit packs. Also, the bold font is
used throughout this manual for emphasis.
FT-2000 Installation 0
The 365-575-115,
FT-2000 OC-48 Lightwave System, Releases 3 through 8.1,
Installation Manual
is available for customers planning to install the equipment
themselves. To acquire this manual, refer to "How to Order Documents" in the
About This Document tab.
FT-2000 Software Release Description 0
Different releases have different comcode numbers and/or document numbers but
all documents contain information such as known problems, problems that have
been fixed from an earlier release, and upgrade/download procedures. For the
specific release and document, refer to the Operation: NTP-002 or to the
"Related Documentation/Training" part of the "About This Document" section at
the beginning of this manual.
To Next Page
Loading...