Lucent Technologies FT-2000 OC-48 - Page 933

365-575-102 Operation and Maintenance: IXL-001
Issue 8.0, July 2002 Page 9 of 14
FT-2000 MULTIPLEXER
Numerical List of TOP Procedures
Table A – Numerical List of TOP Procedures (Note)
*
Acceptance Tab
IXL-001 Task Index — Acceptance
NTP-002 Accept FT-2000 OC-48 1x1 End Terminal
NTP-003 Accept FT-2000 Point-to-Point Network
NTP-004 Accept Protection Access Upgrade in Point-to-Point Network
NTP-005 Accept FT-2000 OC-48 Repeater Bay/Shelf
NTP-006 Accept FT-2000 OC-48 Add/Drop-Rings Terminal for 2-Fiber Ring
NTP-007 Accept FT-2000 2-Fiber Ring Network
NTP-008 Accept Added Electrical Low-Speed Cables to an In-Service FT-2000
Network Element
NTP-009 Accept Dual Ring Interworking (DRI) Connections To/From an FT-2000
Ring
NTP-010 Accept Added Optical Low-Speed Fibers to an In-Service FT-2000
Network Element
NTP-011 Accept FT-2000 OC-48 Add/Drop-Rings Terminal for Operation With
an FT-2000 Lightwave Booster Amplifier (FT-LBA)
System Turnup/Circuit Order Tab
IXL-001 Task Index — System Turnup/Circuit Order
NTP-002 Add DS3 and/or EC1 Low-Speed Port(s)
NTP-003 Delete DS3 and/or EC1 Low-Speed Port(s)
NTP-004 Delete OC-48 Protection Line From Point-to-Point Network
NTP-005 Add OC-48 Protection Line to Point-to-Point Network
NTP-006 Discontinue Restoration Protection Access From Point-to-Point
Network
NTP-007 Establish Restoration Protection Access in Point-to-Point Network
NTP-008 Add a Node to an In-Service 2-Fiber Ring Network
NTP-009 DeleteaNodeFromanIn-Service2-FiberRingNetwork
NTP-010 Add OC-3/IS-3 Low-Speed Slot(s)
NTP-011 Remove OC-3/IS-3 Low-Speed Circuit Pack(s) From the Shelf
NTP-012 Add OC-12 Low-Speed Slot(s)
NTP-013 Delete OC-12 Low-Speed Slot(s)
NTP-014 Change an OC-3/IS-3 Link From 0x1 to 1+1ProtectionMode
NTP-015 Change an OC-12 Link From 0x1 to 1+1ProtectionMode