Lucent Technologies FT-2000 OC-48 - Page 950

NTP-004: Acceptance 365-575-102
Page2of4 Issue8.0,July2002
4. At the local FT-2000 network element, does the
report indicate that Restoration Protection Access
has been provisioned to "yes"?
If YES, then continue with Step 5.
If NO, then continue with Step 6.
5. At the local FT-2000 network element and at the
CIT, select CONFIGURATION-Set-Protection-Line
and set Restoration Protection Access to no.
—
6. At the local FT-2000 network element, remove all
DS3 inputs and outputs at the DSX-3
cross-connect panel or equivalent for the
protection access shelf.
—
7. At the local FT-2000 network element and at the
CIT, select CONFIGURATION-Update and
execute.
—
8. At the remote FT-2000 end terminal, have
someone repeat Steps 1 through 7.
—
9. At the local FT-2000 end terminal and at the CIT,
select FAULT-Switch-Line for line P with priority
set to Reset.
—
10. At the local FT-2000 end terminal CIT, select
FAULT (CONFIGURATION for Release 1) and
perform the low-speed cabling test.
DLP-503
11. At the remote FT-2000 end terminal CIT, select
FAULT (CONFIGURATION for Release 1) and
perform the low-speed cabling test.
DLP-503
12. At the local FT-2000 end terminal CIT, select
FAULT and perform the system automatic turnup
test.
DLP-507
DO ITEMS BELOW IN ORDER LISTED . . . . . . . FOR DETAILS, GO TO