Mitel 430 - Page 364

Features
364
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
Detailed Description
Tab. 170 Conference bridge
Notes:
– The conference rooms remain saved until they are deleted again via Self Service Portal or
WebAdmin (system assistant authorization level).
– An active conference remains active as long as at least one participant is in the conference
room. This is an important difference compared to the other conferences described in the
previous chapters.
– Other conference participants can be connected from an existing active conference through
enquiry calls (see "Three-party conference from an enquiry call", page 362).
– It is not possible to dial in to a conference room from an enquiry call.
Suffix dialling functions
Tab. 171 Conference bridge: Functions
System configuration
To set up a conference bridge, some configurations are necessary both for the admin-
istrator in WebAdmin and for a user in Self Service Portal:
End point Operating sequence / signalling on terminal Scope
A, B, C, D Conference participants A, B, C and D choose, at a predefined
time, the internal or external dial-in number and are prompted to
enter
1)
the conference PIN.
The first participant is informed that he is the first participant and
is requested to wait. Once a second participant joins the confer-
ence, both participants are informed that they are now connected
to the conference. Then, depending on system configuration, they
will hear:
• no tone at all
• the conference tone only once
• the conference tone regularly
The conference and, depending on system phone type, the num-
ber of conference participants or call numbers/names are dis-
played on the phone screen.
1)
For this, an audio guide must be loaded.
Possible interfaces:
internal, external
2)
, PISN
2)
Restriction:
A maximum of 6 conference partic-
ipants are permitted per confer-
ence room.
2)
If one or more users are external users or virtual network PISN users, the settings authorising exchange-to-
exchange traffic will have to be observed (see "Exchange-to-Exchange Connections", page 224
).
Functions System phones Analogue terminal
Expand conference from enquiry call: •
• Use digit suffix dialling: 3
with R3 (R = control key)
Exclude internal conference participants (from enquiry
call). The external connection is maintained.
Note:
PISN users are not excluded.
1)
1)
Applies to mixed conference with one or more internal and one or more external conference participants.
#71 with R#71