Mitel 430 - Page 447

Features
447
System functions and features as of R4.1
syd-0570/1.2 – R4.1 – 08.2016
Notes:
– A user can only carry out the function if he has been allocated an authorization profile with
the right Audio services. Also the user PIN must not be set to the default value "0000".
Exception: The function for checking the recording is not affected by this restriction.
– A PISN user can only operate the control functions of his own local communication server
using the */# function codes.
Recording with the phone:
After the function code is entered, a start tone is audible and can be recorded over the
handset.
Note:
Loss of quality is to be expected when recording using DECT, IP or SIP phones.
Recording with audio equipment:
After the function code is entered, a start tone is audible, and it can be played back via
the audio input on the communication server. The recording can be monitored via the
handset.
The following applies to both recording possibilities:
• To end the recording, hang up; on system phones press the Stop key. The recording
is then stored automatically.
• The recording time is limited by the length of time defined in for this recorded an-
nouncement in the file system. Once this time has expired, the recording stops auto-
matically and the audio data is stored.
Recording with the PC:
Announcements can also be recorded with a PC through a connected microphone.
The recordings have to be stored as wave files in a particular format.
• Format: CCITT A-Law, 8 kHz, 8 bit, mono
• File name extension: ".wav"
The wave files with the announcements must be uploaded onto the communication
server’s file system. The files are available to the application as soon as they are on
the communication server file system. We recommend that you use the corresponding
function codes to check the texts by listening to it (see Tab. 276
).
Check recording *#911 xx [*nn] # or *#921 xx [*nn] #
Delete recording #911 xx [*nn] # or #921 xx [*nn] #
1)
"xx": File number <10...29>
"[ ]": the digits inside the brackets are optional
"nn" stands for the node number. If no node number is indicated, the node used is that of the phone with
which the functions are carried out. With IP system phones this is always the Master; with cordless phones it
is the node at which the phone is currently located.)
Functions Function codes
1)