Note – Ensure Application Filter Log Alert is enabled.
Refer to Security > Firewall > Application Filter tab. Check Log Alert and save the setting.
IPS Status
Figure 35 – IPS Status
Item Value setting Description
Detected
Intrusion
System data. This is the intrusion type of the packets being blocked.
IP System data. The Source IP (IPv4) of the logged packet.
Time System data. The Date and Time stamp of the logged packet. Date & time
format. ("Month" "Day" "Hours":"Minutes":"Seconds")
Table 27 – IPS Status
Note – Ensure IPS Log Alert is enabled.
Refer to Security > Firewall > IPS tab. Check Log Alert and save the setting.
Firewall Options Status
Figure 36 – Firewall Options Status
Item Value setting Description
Stealth Mode
System data. Enable or Disable setting status of Stealth Mode on Firewall Options.
String Format: Disable or Enable
SPI
System data. Enable or Disable setting status of SPI on Firewall Options.
String Format : Disable or Enable
Discard Ping
from WAN
System data. Enable or Disable setting status of Discard Ping from WAN on
Firewall Options.
String Format: Disable or Enable
Remote
Administrator
Management
System data. Enable or Disable setting status of Remote Administrator.
If Remote Administrator is enabled, it shows the currently logged in
administrator’s source IP address and login user name and the login
time.
Format:
IP : "Source IP", User Name: "Login User Name", Time: "Date time"
Example:
IP: 192.168.127.39, User Name: admin, Time: Mar 3 01:34:13
To Next Page
Loading...