Parker EME
Introduction
192-121102 N04 June 2008 15
1.2.3. Special safety instructions
Check the correct association of the device and its documentation.
Never detach electrical connections while voltage is applied to them.
Safety devices must be provided to prevent human contact with moving or
rotating parts.
Make sure that the device is operated only when it is in perfect condition.
Implement and activate the stipulated safety functions and devices.
Operate the device only with the housing closed.
Make sure that all axes are sufficiently fixed.
Attention during configuration downloads with master - slave couplings (electronic
gear, cam)
Deactivate the drive before starting the configuration download: Master and Slave
axis
1.3 Warranty conditions
The device must not be opened.
Do not make any modifications to the device, except for those described in the
manual.
Make connections to the inputs, outputs and interfaces only in the manner
described in the manual.
Fix the devices according to our mounting instructions. (see page 40)
We cannot provide any guarantee for any other mounting methods.
Note on exchange of options
Compax3 options must be exchanged in the factory to ensure hardware and
software compatibility.
1.4 Conditions of utilization for CE-conform operation
- Industry and trade -
The EC guidelines for electromagnetic compatibility 2006/95/EC and for electrical
operating devices for utilization within certain voltage limits 2004/108/EC are
fulfilled when the following boundary conditions are observed:
Operation of the devices only in the condition in which they were delivered,
i.e. with all housing panels.
Shielding connection of the valve cables
The cable should be fully screened and connected to the Compax3 housing. We
offer a special Shield connecting terminal (see page 432) as accessory item
(ZBH./...).
The shi
eld of the valve cable must also be connected with the valve housing. The
fixing (via plug or screw in the terminal box) depends on the valve type.
To Next Page
Loading...
