Parker EME
Motion control
192-121102 N04 June 2008 225
Setpoint generator: Coupling and decoupling curves
Enable the curve slave position.
Alignment / adjustment of the curve slave position to the actual slave position.
For this the following IEC modules are available
MC_CamIn: Coupling with relative slave reference.
C3_CamIn: Coupling with absolute slave reference with coupling function, master
coupling position and master synchronous position
C3_CamOut: Decoupling with absolute slave reference with coupling function,
master decoupling position, master braking position and slave standstill position.
5.10.5.2 Signal image
Displayed are 2 different signal plans, which differ in their master reference:
absolute master reference
relative master reference
Displayed are:
the master signal processing,
the function of the individual IEC function modules as well as
the status objects made available for the commissioning or processing.
Please make yourself familiar with the
Symbols of the signal image (see page
228).
RV:
Reset distance of the virtual master (from C3 ServoManager wizard
”signal source”)
RM Cam:
Reset distance of the master from curve
RS:
Reset distance of the slave (from C3 ServoManger Wizard
”configuration: Reference system)
MD:
Feed of the master axis
SD:
Feed of the slave axis
Symbols
Abbreviations:
To Next Page
Loading...
