Parker Compax3 Fluid T40 User Manual

Specifications
C3F_T40
454 192-121102 N04 June 2008
Technical data
Motion control with motion profiles, suitable for position and force/pressure control
for up to 2 axes.
Command value generator
 Jerk-limited ramps.
 Travel data in increments, mm, inch.
 Specification of speed, acceleration, delay and jerk factor.
 Force/pressure data in N, bar, psi.
Monitoring functions
 Voltage range.
 Following error monitoring.
 Hard and Software limit switch
Technology functions of servo controllers
 IEC61131-3 programs in the servo controller (T30)
 Cam function in the servo controller (T40)
Voltage supply 24VDC
Controller type Compax3 F001 D2
Voltage range
21 - 27VDC
Mains module
with switch-on current limitation, due to
capacitive load
Fuse
MTP miniature circuit breaker or "delayed action
fuse", due to capacitive load
Current drain of the device
0.8A (max. 1.5A)
Total current drain
0.8A + total load of the digital outputs
Ripple
<1Vss
Requirement according to safe extra
low voltage (SELV)
yes
Size / weight
Controller type Compax3 F001 D2
Dimensions: HxWxD [mm]
199x80x130
Weight [kg]
2.0
Housing / protection class
Enclosed metal housing, insulation according to
EN60529 / IP 20
12. Specifications

Parker Compax3 Fluid T40 Specifications

General

Series	Compax3
Power Supply Voltage	24 VDC
Output Current	40A
Protection Class	IP20
Communication	CANopen, RS232
Operating Temperature	0°C to +45°C
Relative Humidity	5 to 95 %, non-condensing
Storage Temperature	-25 to +70 °C