Motion control C3F_T40
214 192-121102 N04 June 2008
5.10.4. Generating cams
In this chapter you can read about:
Introduction to the CamDesigner (example).....................................................................215
Cam functions of the Compax3 ServoManager / motion laws .........................................220
The curve creation software "C3 CamDesigner" is a separate program and must
therefore be installed separately.
You will find the program on the Compax3 CD.
Please note:
The CamDesigner must be installed in a folder, whose name does not contain any
blanks.
This problem occurs above all when working with english Windows versions
(...\Program Files\...).
To Next Page
Loading...
