Parker Compax3 Fluid T40 User Manual

Compax3 Accessories C3F_T40
452 192-121102 N04 June 2008
11.8 CAN - plug BUS10/01
We offer a CAN plug and special cable in any length to order for the CAN-bus
wiring:
 CAN cable: SSL02/.. not prefabricated (colour according to DESINA).
 CAN plug: BUS10/01 with 2 cable inputs and screw terminals as well as a switch
for activating the terminal resistor.
The terminal resistor must be activated on the first and on the last station
(=switch setting ON).
Note for integrated C3 powerPLmC (Compax3 interface designation "C1x")
 The CAN bus of the C3 powerPLmC does already contain a terminal resistor.
 Therefore it applies for the C3 powerPLmC:
Put switch to OFF
wire C3 powerPLmC always at the end of the CAN bus!
CAN wiring
Schaltbild
Circuit Diagram
Kabel abisolieren
Cable stripping
CAN-GND 1
CAN-L 2
CAN-H 3
CAN-L 4
CAN-H 5
CAN-GND 6
2
1
6
3
5
4
7
8
9
ON
OFF
ON
OFF
R1
120 Ohm
0,25W
S1
Kabelschirm
Shielding on cable
Shielding on housing
Gehäuseschirm
Printklemme
Print terminal
X1
X2
Federleiste
D-Sub female
10mm 7mm
max.
5mm

Parker Compax3 Fluid T40 Specifications

General

Series	Compax3
Power Supply Voltage	24 VDC
Output Current	40A
Protection Class	IP20
Communication	CANopen, RS232
Operating Temperature	0°C to +45°C
Relative Humidity	5 to 95 %, non-condensing
Storage Temperature	-25 to +70 °C