Parker Compax3 Fluid T40 User Manual

Index
C3F_T40
462 192-121102 N04 June 2008
Adjust force / pressure
(C3_PressureForceAbsolute) • 202
Adjusting the bus address • 32, 33, 35
Adjusting the machine zero proximity switch •
69
Alignment of the slave axis • 245
Analog / Encoder (plug X11) • 28
Analog Input • 118
Analog Input (plug X1) • 25
Analog Output (plug X2) • 26
Analogue Inputs/Outputs • 426
Application note
Drift • 285
ASCII - record • 345
Assignment of the process data channel • 354
Assignment of the X22 connector • 446
B
Back stop • 212
Basic procedure • 212
Basics • 210
Baud rate • 367
Behavior depending on the travel direction •
292
Behavior of the switch-on/switch-off
anticipation • 292
Binary record • 346
Bit sequence V2 • 364
Braking position (MB) • 212
Bus format Y2 and Y4 • 363
Byte string OS • 364
C
C3 • 303, 304
C3 Master PIO • 367
C3 settings for RS485 four wire operation •
343
C3 settings for RS485 two wire operation • 342
C3.AnalogInput0_Offset • 118
C3.AnalogInput1_Offset • 119
C3.AnalogInput2_Offset • 120
C3.AnalogInput3_Offset • 121
C3.AnalogInput4_Offset • 121
C3.AnalogInput5_Offset • 122
C3.ControllerTuning_2_AccelFeedback_Ka •
115
C3.ControllerTuning_2_FilterAccel2 • 117
C3.ControllerTuning_2_FilterSpeed2 • 117
C3.ControllerTuning_2_SpeedFeedback_Kv •
115
C3.ControllerTuning_AccelFeedback_Ka • 112
C3.ControllerTuning_FilterAccel2 • 116
C3.ControllerTuning_FilterSpeed2 • 116
C3.ControllerTuning_SpeedFeedback_Kv •
111
C3.DirectionDependentGain_Ch0_Factor_neg
ative_Pressure • 134
C3.DirectionDependentGain_Ch0_Factor_posi
tiv_Pressure • 134
C3.FeedForward_2_Accel_FFW • 108
C3.FeedForward_2_Speed_FFW • 108
C3.FeedForward_Speed_FFW • 107
C3.PositionController_2_TrackingErrorFilter_u
s • 113
C3.PressureController_1_ActuatingSignalFilter
• 126
C3.PressureController_1_TimeDelay_DT1_T1
• 125
C3.PressureController_2_ActuatingSignalFilter
• 130
C3.PressureController_2_TimeDelay_DT1_T1
• 129
C3.SpeedController_ActuatingSignal_filt • 112
C3.SpeedController2_ActuatingSignal_filt •
115
C3_CamIn • 248
C3_CamOut • 256
C3_CamTableSelect • 239
C3_CANopen_AddNode • 371
C3_CANopen_ConfigNode • 372
C3_CANopen_GuardingState • 370
C3_CANopen_NMT • 373
C3_CANopen_SDO_Read4 • 374
C3_CANopen_SDO_Write4 • 375
C3_CANopen_State • 369
C3_Input • 302
C3_IOAddition_0 • 303
C3_IOAddition_1 • 303
C3_IOAddition_2 • 304
C3_Jog • 189
C3_MasterConfig • 242
C3_MasterControl • 236
C3_Output • 302
C3_OutputSelect • 290
C3_ReadArray • 172
C3_SetControlMode • 169
C3_SetErrorReaction • 301
C3_SetMaster • 235
C3_ShiftPosition • 200
C3_TouchProbe • 305
C3HydraulicsManager • 44
C3Plus.AnalogInput0_FilterCoefficient • 119
C3Plus.AnalogInput0_Offset_normed • 118
C3Plus.AnalogInput1_FilterCoefficient • 119
C3Plus.AnalogInput1_Offset_normed • 119
C3Plus.AnalogInput2_FilterCoefficient • 120
C3Plus.AnalogInput2_Offset_normed • 120
C3Plus.AnalogInput3_FilterCoefficient • 121
C3Plus.AnalogInput3_Offset_normed • 120
C3Plus.AnalogInput4_FilterCoefficient • 122
C3Plus.AnalogInput4_Offset_normed • 121
C3Plus.AnalogInput5_FilterCoefficient • 122
C3Plus.AnalogInput5_Offset_normed • 122
C3Plus.DeadBandCompensation_Ch0_A_Side
• 136
C3Plus.DeadBandCompensation_Ch0_B_Side
• 136
C3Plus.DeadBandCompensation_Ch0_Thresh
old • 137
C3Plus.DeadBandCompensation_Ch0_Type •
136
C3Plus.DirectionDependentGain_Ch0_Factor_
negative • 134

Parker Compax3 Fluid T40 Specifications

General

Series	Compax3
Power Supply Voltage	24 VDC
Output Current	40A
Protection Class	IP20
Communication	CANopen, RS232
Operating Temperature	0°C to +45°C
Relative Humidity	5 to 95 %, non-condensing
Storage Temperature	-25 to +70 °C