Ricoh A229 - Inputting a Value or Setting for an SP Mode

SERVICE PROGRAM MODE
4-9
SM A229
Service
Tables
Inputting a Value or Setting for an SP Mode
1. Select the required program mode as explained on the previous page.
2. Enter the required setting using the ten-key pad, then touch the “Start” key or
OK key or 7 key.
NOTE: 1) If you forget to touch the “Start” key or OK key, the previous value
remains.
2) To change from “+” to “-“ use the “•” key before entering the required
value, to change from - to + use the Clear/Stop key.
3. Exit SP mode.
Rev. 12/15/98