Ricoh A229 - Software Reset; System Setting and Copy Setting (up Mode) Reset; System Setting Reset; Copy Features Reset

SERVICE PROGRAM MODE
4-60
A229 SM
4.2.8 SOFTWARE RESET
The software can be reset when the machine hangs up. Use the following
procedure.
Either
Turn the main power switch off and on.
Or
Hold down the “#” key and “
.
” key at the same time for over 10 seconds.
4.2.9 SYSTEM SETTING AND COPY SETTING (UP MODE) RESET
System Setting Reset
The system settings in the UP mode can be reset to their defaults using the
following procedure.
1. Make sure that the machine is in the copier standby mode.
2. Press the User Tools key.
3. Hold down the “#” key and touch the “System Setting” key.
4. A confirmation message will be displayed, then press “Yes”.
Copy Features Reset
The copy settings in the UP mode can be reset to their defaults using the following
procedure.
1. Make sure that the machine is in the copier standby mode.
2. Press the User Tools key.
3. Hold down the “#” key and touch “Copy Features” key.
4. A confirmation message will be displayed, then press “Yes”.