PAPER FEED
SM 5-81 A229
Replacement
and
Adjustmen
t
5.8.16 COPIER FEED UNIT REMOVAL
1. Remove the development unit. (Refer to Development Unit Removal.)
2. Remove the right inner cover and the registration roller knob. (Refer to
Registration Sensor Removal.)
3. Remove the by-pass feed motor. (Refer to By-pass Feed Motor/Clutch
Removal.)
4. Remove the three connectors [A] for the guide plate solenoid, the pick-up
solenoid, and the relay clutch.
NOTE:
Before disconnecting the connectors, make sure to identify them. Some
of the connectors use identical pin leads but they are not
interchangeable. Take special care not to misconnect the guide plate
solenoid and registration clutch connectors.
5. Remove the upper right cover and the paper feed unit cover. (Refer to Cover
Removal.)
A229R623.WMF
[A]
To Next Page