Message Cause Solution
Locked Print, Hold Print or
Stored Print file.
Alternatively, reduce the data size of the
Sample Print, Locked Print, Hold Print or
Stored Print file.
"HDD is full." When printing with the
PostScript 3 printer driver, the
HDD's capacity for fonts and
forms has been exceeded.
Delete unneeded forms or fonts
registered in the machine.
"Hardware Problem:
Ethernet"
An error has occurred in the
Ethernet board.
Turn off the main power switch, and
back on again. If the message appears
again, contact your service
representative.
"Hardware Problem: HDD" An error has occurred in the
hard disk drive.
Turn off the main power switch, and
back on again. If the message appears
again, contact your service
representative.
"Hardware Problem: Parallel
I/F"
An error has occurred in the
parallel interface board.
Turn off the main power switch, and
back on again. If the message appears
again, contact your service
representative.
"Hardware Problem: USB" An error has occurred in the
USB interface.
Turn off the main power switch, and
back on again. If the message appears
again, contact your service
representative.
"Hardware Problem:
Wireless Board"
Access to the wireless board
in which the wireless LAN
interface unit is inserted is
possible, but an error was
detected.
Turn off the machine, and check the
wireless board is inserted correctly.
Then, turn the machine on again. If the
message appears again, call your
service representative.
"Hardware Problem:
Wireless Card"
• A wireless card that the
machine cannot use has
been installed.
• An error has occurred
with the wireless card.
Turn off the machine, and check the
wireless card. Then, turn the machine on
again. If the message appears again,
call your service representative.
"I/O buffer overflow" An input buffer overflow
occurred.
• In [Printer Features], under
[System], set [Memory Usage] to
[Font Priority].
4. Troubleshooting When Using the Printer Function
64
To Next Page
Loading...
