Risco ProSYS series - Page 216

216 ProSYS Installation and Programming Manual
EVENT MESSAGE DESCRIPTION
ALARM Z=XXX
Alarm in zone XXX
ALR ABRT P=X
Alarm aborted on Partition X
AMPRX DTCT
Z=XXX
Anti mask proximity detection on BUS zone XXX
AMPRX RSTR
Z=XXX
Anti mask proximity detection restore on BUS zone XXX
ARM A:P=X
C=YY
Group A on partition X is armed by user YY
ARM A:P=X
WB=YY
Group A on partition X is set by wireless keyfob YY
ARM B:P=X
C=YY
Group B on Partition X is armed by user YY
ARM B:P=X
WB=YY
Group B on partition X is set by wireless keyfob YY
ARM C:P=X
C=YY
Group C on Partition X is armed by user YY
ARM C:P=X
WB=YY
Group C on Partition X is set by wireless keyfob YY
ARM D:P=X
C=YY
Group D on Partition X is armed by user YY
ARM D:P=X
WB=YY
Group D on partition X is set by wireless keyfob YY
ARM FAIL P=X
Fail to Arm Partition X by Guard due to not ready zones
ARM:P=X C=YY
Partition X armed by user YY
ARM:P=X
WB=YY
Partition X armed by wirelesskeyfob YY
AUT TST FAIL
Failure of zone self-test
AUTO TEST OK
Automatic zone self-test OK
AUX RS PS=X
Restore of Aux power on power supply ID=X
AUX RS ZE=X
Restore of S. Aux power on zone expander X
AUX TRBL RS
S=X
Auxiliary trouble restore on the siren ID=X
AUX TRBL
SIREN=X
Auxiliary trouble on the siren ID=X
BAT LOAD RS
S=X
Battery load trouble restore from siren ID=X
BAT LOAD
SIREN=X
Battery load trouble from siren ID=X
BAT RST PS=X
Low battery trouble restore from power supply ID=X
BELL RS PS=X
Bell trouble restore in power supply ID=X
BELL TAMPER
Bell tamper alarm