ProSYS Installation and Programming Manual 217
EVENT MESSAGE DESCRIPTION
BELL TMP RS
Bell tamper alarm restore
BOX TAMPER
Box tamper alarm
BOX TMP RS
Box tamper alarm restore
BYPASS
BOX+BELL
Bell and box tampers are bypassed
BYPASS
ZN=XXX
Zone XXX is bypassed
CHARGE CURR
S=X
Battery charging trouble in siren ID=X
CHNG CODE=XX
Changing user code by user XX
CHNG FM=XX
Changing MS telephone number X
CHNG PROG=XX
Change in the Access Control definitions of daily program,
weekly program or access group. Each change will appear in
2 events. The first XX defines the quick key function. The
second XX defines the program number (for example, Access
Group 04)
CHRG CURR RS
S=X
Battery charging trouble restore in siren ID=X
CLK NOT SET
Clock is not set
CLK SET C=XX
Time defined by user No. XX
COM OK AC=X
Bus communication OK with Access Control module X
COM OK ACM
Bus communication OK with the ACM module
COM OK KP=XX
Bus communication restore with keypad ID=XX
COM OK KR=XX
Bus communication OK with Proximity Key Reader XX
COM OK PRN=X
Bus communication OK with the printer module X
COM OK VOICE
Bus communication OK with Advanced Voice module
COM OK WBA=X
Bus communication OK with the wireless keyfob module ID=X
COMM OK
SIREN=X
Bus communication OK with siren ID=X
COMM OK PS=X
Bus communication restore with power supply expander ID=X
COMM OK UO=X
Bus communication restore with UO expander ID=X
COMM OK
Z=XXX
Bus communication OK with BUS zone XXX
COMM OK ZE=X
Bus communication restore with zone expander ID=X
COMM. OK GSM
GSM communication is OK
CP RESET
The control panel has reset
DAT SET C=XX
Date defined by user No. XX
DAY A:P=X
Arm by scheduler of group A on partition X
DAY ARM:P=X
Daily Arm on Partition X
To Next Page
Loading...
Need help?
General
