ProSYS Installation and Programming Manual 221
EVENT MESSAGE DESCRIPTION
MAIN:BAT RST
Low battery trouble restore from the Main Panel
MAIN:LOW AC
Loss of AC power from the Main Panel
MAIN:LOW BAT
Low battery trouble from the Main Panel
MAIN:NO AUX
Failure in the Aux power on Main Panel
MAIN:NO BELL
Bell trouble in Main Panel
MASKED Z=XXX
Anti mask trouble from zone XXX
MS=X CALL
ERROR
Communication fail trouble to MS phone No. X
MS=X RESTORE
Communication fail trouble restore to MS phone No. X
MW RESTORE
Z=XXX
Trouble restore in the MW channel of BUZ zone XXX
MW TROUBLE
Z=XXX
Trouble in the MW channel of BUZ zone XXX
NEXT ARM:P=X
Partition X armed in Next Arm mode
NEXT DIS:P=X
Partition X disarmed in Next Disarm mode
NO AUX PS=X
Failure in the Aux power on power supply ID=X
NO AUX ZE=X
Failure in the S. Aux power on zone expander X
NO BELL PS=X
Bell trouble in power supply ID=X
NO COM AC=X
Bus communication failure with Access Control module X
NO COM ACM
Bus communication failure with the ACM module
NO COM KP=XX
Bus communication failure with keypad ID=XX
NO COM KR=XX
Bus communication failure with Proximity Key Reader XX
NO COM PRN=X
Bus communication failure with the printer module X
NO COM VOICE
Bus communication failure with Advanced Voice module
NO COM WBA=X
Bus communication failure with the wireless keyfob module ID=X
NO COMM PS=X
Bus communication failure with power supply expander ID=X
NO COMM
SIREN=X
Bus communication failure with siren ID=X
NO COMM UO=X
Bus communication failure with UO expander ID=X
NO COMM
Z=XXX
Bus communication failure with BUS zone XXX
NO COMM ZE=X
Bus communication failure with zone expander ID=X
NO COMM. GSM
GSM communication failure
NO FAULT
Z=XXX
Trouble restore in zone XXX (TEOL zone or BUS zone input TEOL)
NO JAM WBA=X
Jamming restore on wireless keyfob expander ID=X
NO JAMM ZE=X
Wireless jamming restore from zone expander ID=X
NO MASK Z=XXX
Anti mask trouble restore from zone XXX
To Next Page
Loading...
Need help?
General
