ProSYS Installation and Programming Manual 39
Accessories: Auto Settings section of Chapter 5, Using the Installer Programming Menus for
further details).
 To access the Installer Programming Menu for the first time (or after the
Main Panel has been defaulted):
1 When you power up the system, the following display appears:
PLEASE WAIT…PLEASE WAIT…
After a brief wait, the following display appears:
TO INSTALL
TO INSTALL
PRESS *
PRESS *
TO INSTALL
TO INSTALL
PRESS *
PRESS *
2 To program the system to recognize the keypad, press
. The following display appears,
prompting you for the Installer code:
3 Enter the default Installer code, depending on the ProSYS model:
O ProSYS 128: [0][1][2][8]
O ProSYS 40: [0][1][4][0]
O ProSYS 16: [0][1][1][6]
The code appears as ,,,, on the keypad display, as follows:
4 The system enters the automatic accessories setting process, and the following display
appears:
NOTE:
Refer to Accessories: Auto Settings section of Chapter 5, Using the Installer Programming Menus for
further details.
The Power/
LED begins flashing slowly at this point, indicating that you have entered a
programming session.
 To access the Installer Programming Menu from the regular operation mode:
When you power up the system, the following display appears:
PLEASE WAIT…PLEASE WAIT…
After a brief wait, the keypad displays the regular operation mode, as follows:
1 Press . The keypad displays the first User Functions option, as follows:
To Next Page
Loading...
Need help?
General
