Testing recipes in process mode
Proceed as follows to test the reaction of the expanded master recipe in process mode:
1. Release your master recipe in the BATCH Control Center (release for testing and
production).
2. Create a new batch in the BatchCC with the master recipe configured above.
3. Release the batch.
4. Start the batch.
5. The master recipe used in the batch waits for your action at the four transitions.
6. Click on the "Jump Test" ROP and select the "Object properties" command in the shortcut
menu.
7. Switch to the "Parameters" tab and click "Change".
8. Depending on your test scenario, select the value "true" for one of the four "JumpTestX"
parameters and then click "OK".
BATCH Recipe Editor
10.4 Creating recipes
SIMATIC BATCH V8.2
554 Operating Manual, 02/2016, A5E35958174-AA
To Next Page
Loading...
