Description of configurations
The configurations below give you an exemplary overview of the different configuration steps
and the possible applications of your processes.
Creating an enumeration
1. Open the "Enumerations" folder in SIMATIC Manager within the "Shared Declarations" of
your project. Create a new enumeration. Example: "TA_states".
2. Create two values for the unit property "UnitState", for example, clean and dirty.
Image 12-4 Creating an enumeration
Recommended procedure
12.8 How do I configure and use dynamic unit parameters?
SIMATIC BATCH V8.2
690 Operating Manual, 02/2016, A5E35958174-AA
To Next Page
Loading...
