Strasbaugh nTellect (Model 7AF) Wafer Grinder
8 - 4 Version 1.2 - June 2004
OPERATOR FUNCTIONS
OVERVIEW
This chapter is designed to provide step-by-step procedures to the machine operator
for operating and maintaining the 7AF Wafer Grinder on a daily basis.
Actions to be taken by the operator are shown in numbered steps with computer
commands printed in bold type.
Messages Displayed on the Control Computer Screen Take Precedence!
Messages and information displayed on the control computer screen always take
precedence over information in this manual.
Because control computer software can be updated more rapidly than manual
information, onscreen directions may be more current than the contents of this manual.
Should the manual and the screen information conflict, always follow the
onscreen directions.
Assumptions
The procedures below were written with the assumption that the reader is thoroughly
familiar with the Model 7AF Wafer Grinder. If not, read the chapters in this manual
on Physical Description, Installation, Mechanical Description, Control System
Description, Power Distribution, and Plumbing Description before beginning any
procedure.
To Next Page
Loading...
