Atmospheric Pre-aligner Manual
4000-0015 Rev 1
7
Regulatory Compliance
The regulatory compliance information and safety requirements in this
chapter are intended for CE-compliant and S2-93A-ready pre-aligners
only:
• To determine if your pre-aligner is CE compliant, check the
manufacturing label for the CE mark. If necessary, request the official
Declaration of Conformity (DOC) from Equipe.
• To determine if your pre-aligner is S2-93A ready, refer to your product
model number. If necessary, request a copy of the third party
Certificate of Compliance (COC).
There are no ergonomic or human factor requirements for the pre-aligner.
CE Mark
The pre-aligner assembly complies with CE Mark requirements following
the provisions of:
• Electromagnetic Compatibility (EMC) Directive
• Low Voltage Directive (LVD)
• Machinery Directive (MD)
The pre-aligner is intended to be integrated into an end-user system. If the
pre-aligner is used in a manner not specified by PRI Automation/Equipe
Division, the protection provided by the assembly is compromised.
EMC and ESD Protection
A third party tested the pre-aligner to ensure electromagnetic compatibility
for both emissions and immunity. The system complies with the EMC
Directive.
For protection against Electromagnetic Interference (EMI), it is strongly
recommended that you mount the pre-aligner directly to equipment
ground, forming a metal-to-metal contact.
Protection against electrostatic discharge (ESD) is designed into the pre-
aligner. The pre-aligner complies with the ESD requirement of the EMC
Directive.
To Next Page
Loading...