Studer D950 - CAS Mode Entry (D950 Only); Vista Mode Entry

D950/Vista7 Digital Mixing System
5-54 AutoTouch+ SW V3.3 Date printed: 27.08.03
5.6.5.3 CAS Mode Entry (D950 only)
CAS Control Mode Entry: The Control Mode for the channel assigned to the CAS can be selected
using the controls in the AUTOMATION section of CAS.
It should be noted that the CAS automation mode will follow those made
at the channel strip or globally.
The CAS Control Mode Activators are organized in three groups of keys:
• Fader
• Mute
• Switches and Encoders (rotaries)
Each group of activators has a key for each Control Mode:
• READ: READ
• ISO: ISOLATE
• ABS: WRITE ENABLE (ABS is a legacy of AutoTouch 2.5)
• TRIM: TRIM ENABLE
Switches and Encoders within the channel can be independently Pre-
Selected for entry into the desired mode. For details, refer to chapters
5.19.1.2, CAS Controls, and 5.10, Switch Automation.
5.6.5.4 Vista Mode Entry
Vista Control Mode Entry: Control Mode entries on the Vista work surface is accomplished using the
same local and global methods as used on the D950 M2 and Classic desks
and the same conditions and options apply.
Local Control Mode Entry: Refer to chapter 5.6.5.2
Global Control Mode Entry: Global Control Mode entry is made as described above. However it should
be noted that the Global Mode Activators are located in the “Enable
Modes” section of the Vista automation panel.