D950 Digital Mixing System
Date printed: 03.09.03 SW V3.3 Desk Operation 3-33
3.3.6.2 Stereo AUX Parameters
The Stereo AUX Section provides selection of the AUX bus (ON/OFF),
send level adjustment, pre-/after-fader switching, and balance setting.
SEND LEVEL: The Send Levels for Stereo AUX 1 through 4 can be adjusted using this
rotary control.
Adjustment range MUTE (i.e. –∞) through +10 dB:
• MUTE through –20 dB, in 1 dB steps,
• –20 through –10 dB, in 0.5 dB steps,
• –10 through +10 dB, in 0.1 dB steps.
Note: 0.5 dB increments are denoted by a decimal point that is not followed by
another number.
0.1 dB increments are always followed by the 1/10
th
-dB value.
For example, –19.5 dB is displayed as “–19.”, and –9.4 is displayed as
“–9.4”.
AUX POSITION: The signal sent to the Stereo AUX bus can be selected pre- or after-fader
using the SW key. Pre-fader is indicated by an illuminated SW key.
PANNING: Either Stereo AUX channel can be attenuated, which provides a L/R pan-
ning function.
• L30_, fully left (i.e. right-hand channel is attenuated by 30 dB),
• _30R, fully right (i.e. left-hand channel is attenuated by 30 dB),
• L00R, center (i.e. both channels are attenuated by 3 dB).
To Next Page
Loading...
