D950/Vista Digital Mixing System
7-54 ConfigTool SW V3.3 Date printed: 05.08.03
7.5.3 Troubleshooting
The Session Configuration Tool was checked at the factory during more
than a year for malfunctions and erroneous operations. Hundreds of differ-
ent configurations were tried, and all sorts of tests have been made. Nev-
ertheless, since there exists an almost infinite number of channel, bus, and
I/O configuration combinations, not all of them could be tested. So it may
happen that on a very rare occasion an error message will be issued during
editing or during the Generate process. A description of some of the typi-
cal error messages is listed below.
7.5.3.1 Errors and Warnings During Generate Process / In Log File
When Inserting a New Function When inserting a new function that exceeds the capacity of the core, the
following dialog will appear:
This message is very likely to appear when the console is operating with
96 kHz, or when switching from 48 to 96 kHz.
If you decide to proceed in generating the configuration regardless of the
warning, the following message will be displayed in the Generate All dia-
log, and the configuration process will be stopped.
Could not find pe for 'Channel Inp Stereo #1 CtrlGrp1'!
Please reduce the requirements of that function
D21m If the configured number of D21m interface channels exceeds the capacity
of the D21m board the following message will be displayed. This can only
happen with 96 kHz configurations.
Unable to Distribute the D21m interfaces of PE D21m Board # 0.
Please reduce the number of channels.
Shared Bus The load balancing of the on-board communication is not always as accu-
rate as it should be. This may happen because assumptions are made dur-
ing load balancing which do not always apply. The following warning will
be displayed in such a case:
Warning: Shared Bus Cycles overflow on board 1, in timeSlot 0.
This does not mean that the configuration does not work. If you want to
make sure that it does work, please send it to the factory for further inves-
tigation.
To Next Page
Loading...
Need help?
General
