D950/Vista Digital Mixing System
7-4 ConfigTool SW V3.3 Date printed: 27.08.03
7.1.1 Where to Install
The Session Configuration Tool may be installed on:
• The Studer D950/Vista Control PC
• Any other PC, provided that above requirements are met
We recommend installation on a PC different than the D950 or Vista con-
trol PC. The program requires a lot of processor power while it is compil-
ing. Whilst it will run without any problem in a multitasking environment
with multiple programs running at the same time, its performance may be
considerably slowed down under such circumstances. If speed is essential,
we recommend running the Session Configuration Tool alone on a PC.
In some cases, the Studer D950/Vista Digital Mixing System may be de-
livered with the Session Configuration Tool already installed.
7.1.2 How to Install
Installing from a Compressed File If you have obtained the Session Configuration Tool in compressed form,
you will start by copying the file (usually called D950Cfg.exe) into the
target directory and then running the self-extracting file. This will decom-
press the original files and create the necessary directories for you.
You need to extract the original files into a root directory of a drive (C, D,
E, ...) on your PC. Please make sure that the “:\ADI_DSP” directory has
been placed directly under the root of your selected drive as indicated
above, otherwise the Configuration Tool may not work properly.
Now please proceed with the instructions found in the paragraph “Check
the installation” below.
Check the Installation
Check the Results: Please use the Windows Explorer to check the results of your work now.
The following (or similar) file structure should now be found on your tar-
get PC (assuming “C” was selected as the target drive):
C:\D950cfg \tmpFiles\(subdirectory) contains temporary files
\aryymmdd.ach DSP Proc. Element architecture file
\CoreFuncyymmdd.lib 48k DSP source code library
\CoreFunc96kyymmdd.lib 96k DSP source code library
\D950CfgTool.exe the Session Configuration program
\mnyymmdd.exe executable used for the core files
\rtyymmdd.a DSP RTOS (operating system library)
yymmdd refers to year month day and indicates the version of the file. This
version number varies from release to release. Please refer to the release
documentation of your specific release in order to check that the files are
correct.
C:\ADI_DSP\21K\Bin \asm21k.exe Sharc assembler file
\go32.exe Sharc assembler file
\ld21k.exe Sharc assembler file
\lib21k.exe Sharc assembler file
C:\ADI_DSP\21K\Etc \a21000.exe Sharc assembler file
\cpp.exe Sharc assembler file
C:\ADI_DSP\21K\Include \def21060.h Sharc assembler file
To Next Page
Loading...
Need help?
General
