D950/Vista Digital Mixing System
Date printed: 05.08.03 SW V3.3 ConfigTool 7-27
double-clicking on the function, or by using the >>>> button. Each of the
functions requires DSP power, therefore it is prudent to keep only the
functions that are really needed. The minimum functions of a channel are:
• Input Selector
• Fader
• Direct Out.
Library / Available Functions In this area, the functions available from the system library are listed. The
list changes slightly depending on the channel type (e.g. master channels
do not have a Pan function available), but most functions are the same for
all channel types. This means that master channels may be configured with
an EQ, or an Aux master can have a limiter if needed. Functions can be
added to the current channel by double-clicking on the function in the li-
brary, or by using the <<<< button.
Please note that several restrictions to the X-bar section apply:
• The X-bar section can contain a maximum of 6 functions.
• “Delay 100 ms” and “Delay 240 ms” must not be used at the same time.
• “4-Band EQ” and “4-Band EQ Notch” must not be used at the same
time.
• “VSP Surround PAN” requires a lot of DSP power and cannot be used
in a full channel, otherwise an error will be displayed during the Gen-
erate process. It is usually sufficient to remove Dynamics or EQ + De-
lay functions to allow fitting of the VSP PAN.
Remove Channels Simply click on the channel type to be removed and hit the “Del” (delete)
key.
F Tip Note how the requirements shown in the “Core Statistics” area in the Core
page change as you add or remove channels, change their number, or
add/remove functions.
7.4.3.2 Function Library
Mono and Stereo Channel Functions:
Input Selector 3-way input selector
Input Selector PreAmp Ctrl 3-way input selector, with a control interface to pre-amplifiers
Input HPF/LPF & Gain variable high-pass and low-pass filters, channel gain ±24 dB
Insert Insert function with dry/wet mix feature
Delay 100 ms VariabIe audio delay 0...100 ms
Delay 240 ms VariabIe audio delay 0...240 ms
4-Band EQ Fully parametric 4-Band EQ with Bell/Shelving switch in the LO and HI
bands, Constant Q/Constant Range switch in the HI-MID and LO-MID
bands
4-Band EQ Notch Fully parametric 4-Band EQ with Bell/Shelving switch in the LO and HI
bands, Constant Q/Constant Range switch in the HI-MID and LO-MID
bands, with additional Notch filter
Dynamics Full dynamics section with Compressor, Limiter, Expander, Gate, Look-
forward circuit and Auto Make-up gain, Sidechain with HP/LP Filter
IPL In-Process-Listen functions, allows listening into various points along the
signal path
Meter Precision metering function, switchable to channel input or after fader.
To Next Page
Loading...
Need help?
General
