EasyManuals Logo

Studer D950 User Manual

Studer D950
648 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #405 background imageLoading...
Page #405 background image
D950/Vista7 Digital Mixing System
Date printed: 27.08.03 SW V3.3 AutoTouch+ 5-75
Clear/All: CLR / ALL: Permits the changing of all of the Pre-Selectors at once. This
key functions as follows:
- If one or more Pre-Selectors are active, then pressing CLR/ALL
clears all of the Pre-Selectors.
- If no Pre-Selectors are active, then ALL Pre-Selectors get active.
- Holding CLR / ALL and pressing PUNCH-IN or PUNCH-OUT will by-
pass the Pre-Selector and select all controls.
5.8.2 Manual Punch-In/Out
The manual PUNCH-IN and PUNCH-OUT activators are located in the Global
Record section of the Automation Master Panel. As described above, the
controls to be punched in and out are chosen using Global Record Pre-
Selectors and then manually “punched in and out” of RECORD using the
PUNCH-IN and PUNCH-OUT activator keys.
Punch-in/Out Activators: PUNCH IN: Pressing PUNCH IN puts the Pre-Selected controls on all
channels <Option> into RECORD (if enabled). As with Control Mode
entries, the controls affected are filtered by the Pre-Selectors that are
currently active.
PUNCH OUT: Pressing PUNCH OUT takes the Pre-Selected controls on
all channels <Option> out of RECORD (if enabled). As with Control
Mode entries, the controls affected are filtered by the Pre-Selectors
that are currently active.
Note: Whenever any control is in RECORD the PUNCH IN and PUNCH OUT keys
are lit.
5.8.3 Write Zone
The Write Zone is a region between two user-specified timecode locations.
When the Write Zone is enabled, recording may take place only within that
timecode region.
Write Zone Functions: When the Write Zone is enabled, the following conditions are in place:
Record is locked out before the Write Zone Begin Time.
Record is locked out after the Write Zone End Time.
Recording is allowed only between the Write Zone Begin and End
Time.
Any controls in RECORD will punch-out at the Write Zone End Time
if timecode is played through the End Time (with or without Auto
Punch-In engaged).
If Auto Punch-In is engaged, enabled controls will punch-in at the Write
Zone Begin Time if timecode is played through the Begin Time.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Studer D950 and is the answer not in the manual?

Studer D950 Specifications

General IconGeneral
BrandStuder
ModelD950
CategoryMusic Mixer
LanguageEnglish

Related product manuals