D950/Vista7 Digital Mixing System
5-114 AutoTouch+ SW V3.3 Date printed: 27.08.03
5.14.7 Scene Capture/Recall
A Scene is a global “snapshot” of the automation status of each control
within the system. There are two buffers in which Scenes may be stored.
Scenes will be stored and can recalled during subsequent sessions.
Note: The term “snapshot” is not the same as a Snapshot in the GC. Snapshot in
this regard refers to a picture of the automation status console-wide.
D950: Vista:
Scene Capture: Holding the STORE key and pressing the SCENE CAPTURE key (D950) or
just CAPT (Vista) will “capture” a Scene in the first buffer. Holding the
AUTO MODE and STORE keys and pressing the SCENE CAPTURE key
(D950) or AUTO MODE and CAPT (Vista) will “capture” a Scene in the
second buffer.
The SCENE RECALL / RCL key will illuminate when a Scene has been
captured in the first buffer. There is no indication of the status of the sec-
ond Scene buffer.
The following controls will be stored within a Scene:
• Controls in RECORD
• Controls that are Held
• Controls that are being touched when the Scene is captured
Note: If no controls are in the states listed above, the existing Scene buffer will
remain intact.
A list of controls and their values will be stored when a Scene is captured.
To Next Page
Loading...
Need help?
General
