Studer D950 - Autotouch+ Panel; D950

D950/Vista7 Digital Mixing System
5-154 AutoTouch+ SW V3.3 Date printed: 27.08.03
5.18 AutoTouch+ Panel
5.18.1 D950
[1] Global CONTROL MODES (see also chapter 5.6)
READ – Sets selected objects (depending on the Pre-Selector setting) into
Read mode.
WRITE ENABLE – Sets selected objects (depending on the Pre-Selector
setting) into Write Enable mode. These parameters are “armed” and can be
put into write (record).
TRIM ENABLE – Sets selected objects (depending on the Pre-Selector set-
ting) into Trim Enable mode. These parameters are “armed” and can be put
into trim (record).
ISOLATE: Isolates selected objects (depending on the Pre-Selector setting).
These objects will not be affected by the automation.
[12]
[11]
[10]
[8]
[7]
[6]
[5]
[4]
[3]
[2]
[1]
[17]
[16]
[9]
[14]
[15]
[13]