D950/Vista7 Digital Mixing System
Date printed: 27.08.03 SW V3.3 AutoTouch+ 5-5
5 AUTOTOUCH+ DYNAMIC AUTOMATION
5.1 Getting Started Quickly
This short introduction to the AutoTouch+ Automation is meant to give
the user an easy entry point in order to start working with the dynamic
automation. For simplicity some facts are not totally accurate and may
have exceptions. Also it is possible to modify the behavior of AutoTouch+
automation very much by varying option settings. In order to get a detailed
overview of all available functions, please refer to chapters 5.2 and up.
For Beginners: We recommend to set the automation to factory default settings. This is
done by exiting the Vista/D950 application and deleting the
C:\D950system\D950Ofla.mop file. After restarting the application, you
have the factory default settings applied.
5.1.1 Basics
The operation is based on the individual channel strip as well as on the
AutoTouch+ panel, located near the center of the console.
Definitions: Objects: An “object” in the context of the AutoTouch+ automation is any channel
parameter, such as a fader, a key (for e.g. switching an EQ on and off), or a
knob (for adjustment of anything like gain, etc.).
“Held” Objects: This is an object being touched with a finger (or an object after being un-
touched, but with the un-touch suppressed by a special mode). Held ob-
jects are indicated by underlined values (Vista), displayed fader values in
dB (Vista) or an associated LED being lit (D950).
To Next Page
Loading...
Need help?
General
