Studer D950 - Mono aux Parameters

D950 Digital Mixing System
Date printed: 03.09.03 SW V3.3 Desk Operation 3-29
3.3.5.2 Mono AUX Parameters
The Mono AUX Section provides selection of the AUX bus (ON/OFF),
send level adjustment, and pre-/after-fader switching.
SEND LEVEL: The Send Levels for Mono AUX 1 through the maximum number config-
ured can be adjusted using this rotary encoder.
Adjustment range MUTE (i.e. –∞) through +10 dB:
• MUTE through –20 dB, in 1 dB steps,
• –20 through –10 dB, in 0.5 dB steps
• –10 through +10 dB, in 0.1 dB steps.
Note: 0.5 dB increments are denoted by a decimal point that is not followed by
another number.
0.1 dB increments are always followed by the 1/10
th
-dB value.
For example, –19.5 dB is displayed as “–19.”, and –9.4 is displayed as
“–9.4”.
AUX POSITION: The signal sent to the Mono AUX bus can be selected Pre- or After-fader
using the SW key. Pre-fader is indicated by an illuminated SW key.