Studer D950 - D19 Devicestemplate.ini

D950 Digital Mixing System
6-34 System Administration SW V3.3 Date printed: 05.12.03
6.9 d19devicesTemplate.ini
Comment=D950D19DeviceResourcesSpecifications for SW Release V2.03
Comment=03.11.98 by JM
; [PHYSICAL_DEV] actual D19 resources
; NumberOfCtrlInterface=corresponds to COM ports assigned to D19 Devices in D950System.ini.
; NumberOfMICAD= corresponds to MicAD resp. MicAD STAGE devices actually present
; NumberOfMP4RC= corresponds to D19 Stagebox 4 Ch. Preamp Cards (MP4RC) actually present
; Note: If NumberOfCtrlInterface=1, NumberOfMICAD or NumberOfMP4RC must be in the range between
; 0 and 16 for MicADs and between 0 and 15 for MP4RCs.
; NumberOfMICAD resp. NumberOfMP4RC can be smaller than defined below ([MICAD_x] resp [MP4RC_x),
; but not greater. MicAds & MP4RC have to be connected separate control interfaces.
[PHYSICAL_DEV]
NumberOfCtrlInterface=2
NumberOfMICAD=6
NumberOfMP4RC=2
; [MICAD_x] first MicAD with logical Micad device No. (starting with 0)
; CtrlInterface= connected to control interface x (1..NumberOfCtrlInterface)
; CtrlChannel= corresponds to CTRL CH selected on the MicADs frontpanel (1..16)
; LinePresent= indicates, if Line Interface is present (Yes/No)
; MCHDigitalOutPresent= indicates, if ADAT output is present (Yes/No)
[MICAD_0]
CtrlInterface=1
CtrlChannel=1
LinePresent=Yes
MCHDigitalOutPresent=Yes
[MICAD_1]
CtrlInterface=1
CtrlChannel=2
LinePresent=Yes
MCHDigitalOutPresent=Yes
[MICAD_2]
CtrlInterface=1
CtrlChannel=3
LinePresent=Yes
MCHDigitalOutPresent=Yes
[MICAD_3]
CtrlInterface=1
CtrlChannel=4
LinePresent=Yes
MCHDigitalOutPresent=Yes
[MICAD_4]
CtrlInterface=1
CtrlChannel=5
LinePresent=Yes
MCHDigitalOutPresent=Yes
[MICAD_5]
CtrlInterface=1
CtrlChannel=6
LinePresent=Yes
MCHDigitalOutPresent=Yes