D950 Digital Mixing System
Date printed: 05.12.03 SW V3.3 System Administration 6-33
[LOG_CTRL_GRP_3]
NumberOf4ChStrips =
NumberOfMpu=
4ChStripNodeAssign0=
4ChStripNodeAssign1=
... ..... .... .
4ChStripNodeAssignX=
CCUNodeAssign=
MPUNodeAssign0=
IsLeftJoystickActiveOnMPU0=
IsRightJoystickActiveOnMPU0=
; [LEVELS_dB] System Level Section
; NominalLevel= Nominal System level in dB
; Headroom= Headroom definition in dB (0/3/4/6/9/10/12/15)
; VULead= Lead of Bargraph VU mode in dB (0/2/3/4/6/8)
; IsVUDecayLow= Sets VU Decay time to same as PPM Decay time
; (Yes/No; dft:no)
; Note: Clip Level (0 dB FS) = NominalLevel + Headroom must be 0..26
; due to external A/D D/A devices (MicAD, MultiDAC etc.)
[LEVELS_dB]
NominalLevel=6
Headroom=9
VULead=4
IsVUDecayLow=No
; [TIMES_ms] System Times Section
; CasPPMDecay= CAS L/R Level Bargraph decay time in ms (dft: 2500 ms)
; CasPeakHold= CAS L/R temporary Peak hold time in ms (dft: 3000 ms)
; CasOVRHold== CAS L/R temporary OVR Led hold time in ms (dft: 5000 ms)
; Note: min. time resolution of CAS is 10 ms; finer settings are truncated.
; CasPPMDecay time is set for the whole bargraph length (51 active Leds);
; with a min. resolution of 10 ms per segment, only increments of 50*10ms = 0.5 sec
; make sense;
[TIMES_ms]
CasPPMDecay=2500
CasPeakHold=3000
CasOVRHold=5000
To Next Page
Loading...
