D950/Vista7 Digital Mixing System
5-76 AutoTouch+ SW V3.3 Date printed: 27.08.03
Enabling the Write Zone: The Write Zone is enabled by checking the “Write Zone Enabled” box in
the AutoTouch+ window. If this box is unchecked the Write Zone has no
affect.
Write Zone Begin Time: The Write Zone Begin Time is the timecode location before which re-
cording is locked out, assuming the Write Zone is enabled. Recording is
allowed only after the Write Zone Begin Time, but only up to the Write
Zone End Time.
Auto Punch-In: If Auto Punch-In is engaged, a punch-in will occur for enabled controls
when the Write Zone Begin Time is encountered.
Write Zone End Time: The Write Zone End Time is the timecode location after which Recording
is locked out, assuming the Write Zone is enabled. Recording is allowed
only before the Write Zone End Time, but only after the Write Zone Begin
Time.
Sync w/Loop Pts: Checking the “Sync with Loop Points” function allows to set the Write
Zone In an Out points, according to the selected cue points in the Auto-
Touch+ window.
Any controls in RECORD will punch-out when the Write Zone End Time
is encountered. This happened whether Auto Punch-In is engaged or not.
Write Zone Begin/End Time Entry:
The Write Zone Begin and End times may be entered in the following
ways:
• Highlighting all or part of the Begin or End Time entry field and typing
in the new time;
• Highlighting all or part of the Begin or End Time entry field and rolling
the time up or down using click/drag methods
• Highlighting all or part of the Begin or End Time entry field and using
the up or down arrow keys
• Selecting a time from the Right-Click menu
• Pressing + or – followed by a numeric value
• Using the “Sync with Loop Points” function.
The Write Zone must be enabled before Begin/End Time entry is permit-
ted.
Hot Keys: Hot Keys are provided to aid in the entry of fixed Begin and End timecode
locations. A complete description of Hot Key functions is provided in the
Appendix.
To Next Page
Loading...
Need help?
General
