Chapter 1 – Before You Begin
Firmware Version 3/4.31.37
CHAPTER 1 BEFORE YOU BEGIN
1.1 WHO SHOULD USE THIS GUIDE
This guide is intended for those individuals at your terminal who will set up and use the MultiLoad II system:
terminal managers, system administrators, terminal operators, technicians, and meter proving personnel,
1.2 HOW THIS GUIDE IS ORGANIZED
The MultiLoad II User Guide is organized by functional procedures. It mirrors the MultiLoad II menu structure.
Each chapter discusses a single procedure or a group of related procedures that are necessary to set up and use
the system. The following table provides an information map to the material in this guide.
Conventions Used in This Guide.
System description, Remote and Local operating
modes, System components, Navigation, Data
Entry, and Getting Started.
3. GUI Configuration
Tool
System Admin, Facility
expert
Purpose, Access, Menu Functions, Navigation, and
Local Control only parameter configuration.
System Admin, Facility
expert
Communication Setup, Equipment Setup, Product
Setup, Presets, Additive Calibration, Access IDs,
System Date and Time.
System Admin, Facility
expert
Flow control configuration for single product delivery
and calibration.
Configuring for different additive control methods:
piston only, pulser input, etc.
7. Swing Arm Setup
and Operation
System Admin, Facility
expert
Swing arm configuration and operation.
System Admin, Technician,
Electrician
Loopback Test; Diagnostics for Bay, Preset, Meter,
Component and Additives
Meter pulse resolution, Meter Factors/Calibration,
Temperature Calibration
View presets, totalizers and meter temperatures.
How to utilize the SD Card to save/load
configurations, load firmware, dump diagnostic data,
and configure automated reports
Phases of Operation, Keypad Entry, Local Control
Operation, Remote Control Operation, TMS
Authorization, SMP Ditto.
To Next Page
Loading...
Need help?
General
