Toptech Systems MultiLoad II User Manual

Chapter 9 – Weights & Measures
245
Firmware Version 3/4.31.37
8.3 IBUTTON READER (EXCLUDING SMP)
Note: If the MultiLoad II is a SMP or does not have a iButton installed, this test is not applicable.
Use the iBUTTON function to verify the operation of ibutton and a driver card.
From the DIAGNOSTICS MENU, choose iBUTTON Reader.
The iButton Reader Test screen displays. After placing a ibutton at the reader the screen will update after each
read of the ibutton.
8.4 LOOPBACK TEST
The Loopback Test is used for two purposes:
- To test the transmit and receive capabilities of Host COM Port on MultiLoad II.
- To troubleshoot serial communication problems between MultiLoad II and the host system (TMS).
From the DIAGNOSTIC MENU, choose COM Loopback.
iBUTTON DIAGNOSTICS
Read Count: 00005
iButton ID: 000032AF532
Exit Clear
D I A G N O S T I C S M E N U
iButton Reader Meters
COM Loopback Components
Serial Ports Additives
Network Test Sampler
Keypad Tanks
Display Custom Logic
Unicode
FCM Com
PCM Com
FCM Health
PCM Health
RCU
Bay
Preset
Next Prev Exit Enter

Toptech Systems MultiLoad II Specifications

General

Brand	Toptech Systems
Model	MultiLoad II
Category	Control Unit
Language	English