Toptech Systems MultiLoad II

Chapter 13 – Custom Logic
418
Firmware Version 3/4.31.37
13.2.10 NETWORKING
E-mail Message:
The E-mail Messages function gives you the ability to send off an email message to the email address that is
configured in the Network Settings.
Select one of the 10 messages that you would like to send. Once you have selected a message to be sent, select
a custom logic line that will trigger the MultiLoad to send it to the email address configured in the Network
settings.
Note: Go to Main Menu -> Configuration -> Network -> E-Mail Setup -> Email Messages in order to customize
any of these messages.
Modbus Read:
SELECT CUSTOM LOGIC NETWORK PARAMETER
EMAIL MSG______
MODBUS READ 16
MODBUS READ 32
MODBUS WRITE 16
MODBUS WRITE 32
Next Prev Exit Enter
SELECT MESSAGE PARAMETER
THIS IS EMAIL MESSSA
THIS IS EMAIL MESSSA
THIS IS EMAIL MESSSA
THIS IS EMAIL MESSSA
THIS IS EMAIL MESSSA
THIS IS EMAIL MESSSA
THIS IS EMAIL MESSSA
THIS IS EMAIL MESSSA
THIS IS EMAIL MESSSA
THIS IS EMAIL MESSSA
Next Prev Exit Enter