Toptech Systems MultiLoad II User Manual

Chapter 6 – Additive Control
235
Firmware Version 3/4.31.37
Flushing Systems that use Multiple Block Valves on a Common Additive Meter
If the additive meter is in the flush path, it will generate pulses during the flush phase, when additive is no longer
being delivered. In such a case, enable the Meter Flushed parameter. Meter pulses will then be ignored during
the flush phase. Refer to the diagram.
Add #1 Add #2
M
Additive Block Valve
Add #1
P
Flush Pump
Figure 6.12 Additive Meter in Flush Path

Toptech Systems MultiLoad II Specifications

General

Brand	Toptech Systems
Model	MultiLoad II
Category	Control Unit
Language	English