Firmware Version 3/4.31.37
Select Enter. The sampler is defined automatically, and it is composed of %100 of itself. If you were to select
Edit Product Recipe, the new base additive would be displayed on the Product Recipe screen, shown below.
(Normally, however, there would be no need to go to the Product Recipe screen when establishing sampler, base
additives and base product components.)
Select Exit to return to the Select Product screen.
Continue to define your sampler, as necessary.
4.15 DEFINING SALEABLE PRODUCTS
After defining the base components and base additives, begin defining saleable products. The system defines a
single saleable product (Product) as composed of 1 to 8 base components and 0 to 6 additives. .
Up until this point, the Product Recipe screen has not been necessary, since each base component and additive
is automatically defined as 100% of itself. For defining saleable products, however, the Product Recipe screen
becomes central to product definition.
PRODUCT (AD720 ADDSP0720 ) RECIPE
Samp: %100.00 SAMP720 SAMP0720
Comp: %0.00 (---undefined---)
Samp: 0.0000 SAMP720 SAMP0720
Adtv: %0.0000 (---undefined---)
Next Prev Exit Enter
To Next Page
Loading...
Need help?
General
