Toptech Systems MultiLoad II User Manual

Chapter 4 – General Configuration
67
Firmware Version 3/4.31.37
4.3 NETWORK SETUP
Use the Network Setup function to define the network parameters for the Ethernet port.
Navigate to this screen as: Program Mode -> Configuration -> Network
The NETWORK SETUP screen displays:
Parameter
Description
MAC Address
This is a read only parameter and indicates the hardware MAC address of the Ethernet
port. This number is unique, assigned at the factory and cannot be modified.
OpenSSL Version
Displays the current version number of OpenSSL being used by the MultiLoad
Network
Static or DHCP or Disables the Ethernet port. If the Ethernet port is enabled without a
network connection, startup may have a 10-20 second delay while the connection is
checked.
IP Address
Static IP address assigned to the unit. This value should come from the local network
administrator and should be unique to the local network. Dynamic IP address (DHCP)
is not supported.
NETWORK SETUP
Network Restart
E-Mail Setup
FTP Server Setup
NTP Server Setup
Next Prev Exit Enter
NETWORK SETUP
MAC Address: 00:50:c2:60:90:00
OpenSSL Version: OpenSSL 1.0.1h
Network: DISABLD
IP Address: 192.168.0.200
IP Mask: 255.255.255.0
IP Gateway: 192.168.0.1
IP Host: 192.168.0.1
IP DNS: 0.0.0.0
Host SetupModbus Setup
Termserver Setup
Webpage Setup
Network Printer Setup
TDS/UAP Interface Setup
Next Prev Exit Enter

Toptech Systems MultiLoad II Specifications

General

Brand	Toptech Systems
Model	MultiLoad II
Category	Control Unit
Language	English