Toptech Systems MultiLoad II User Manual

Chapter 4 – General Configuration
91
Firmware Version 3/4.31.37
Access IDs
This is a 1-10 level that the User or Access level setting is compared to when attempting
a parameter change in the Access IDs setup.
Date and Time
This is a 1-10 level that the User or Access level setting is compared to when attempting
a parameter change in the RCU Date/Time setup.
Trace
This is a 1-10 level that the User or Access level setting is compared to when attempting
a parameter change in the Trace setup.
Alibi Level
This is a 1-10 level that the User or Access level setting is compared to when attempting
a parameter change in the Alibi Log label setup.
Hazard Level
This is a 1-10 level that the User or Access level setting is compared to when attempting
a parameter change in the Hazard definitions setup.
Prompts
This is a 1-10 level that the User or Access level setting is compared to when attempting
a parameter change in the prompts setup.
BOL
This is a 1-10 level that the User or Access level setting is compared to when attempting
a parameter change in the Standalone BOL setup.
SD Card
This is a 1-10 level that the User or Access level setting is compared to when attempting
to doing anything via the SD Card.
Host
This is a 1-10 level that the User or Access level setting is compared to when attempting
a parameter change for custom logic, FCM, meters, external preset status, tanks,
products, picklists, Authorized Driver, Stockholder, Customer, Account, Consignee,
Driver Name, customer logo palette, customer logo bitmap, bitmap, or firmware from
Ethernet or serial source.
Factory Defaults
This is a 1-10 level that the User or Access level setting is compared to when attempting
to set Factory Defaults.
4.6.3 EXTERNAL ACCESS LEVEL SETUP
Much like that of a user having an assigned security level with a potential rights limitation on what parameters
they can change, there are other sources outside of a user that has ability to modify parameters. These sources
are communications such as Network/Ethernet, serial communications, custom logic, and in further detail,
Modbus communications. These Access points now have security levels assigned to each that, once again, like a
user, when applying a change, would be judged against the parameters security level to be equal to or greater
than it.
EXTERNAL ACCESS LEVEL SETUP
Comm 0: 10-Administrator
Comm 1: 10-Administrator
Comm 2: 10-Administrator
Network: 10-Administrator
Custom Logic: 10-Administrator
Modbus RTU: 10-Administrator
Modbus TCP: 10-Administrator
Next Prev Exit Enter

Toptech Systems MultiLoad II Specifications

General

Brand	Toptech Systems
Model	MultiLoad II
Category	Control Unit
Language	English